How to Apply Strip Lashes Like a Pro: Step-by-Step for Beginners

How to Apply Strip Lashes Like a Pro: Step-by-Step for Beginners

 

 

Beginner lash tutorial

How to Apply Strip Lashes Without Lifting Corners

If you want to learn how to apply strip lashes without the corners lifting, the band sitting too high, or the lash looking obvious, this guide will help. Strip lashes can instantly lift your makeup, but the result depends on fit, glue timing and placement.

This strip lash tutorial covers strip lashes application, how to put on strip lashes, how to apply strip lashes for beginners, how to apply strip lash glue properly, how to trim strip lashes and how to stop strip lash corners from lifting.

Quick answer

To apply strip lashes: measure and trim the lash to fit your eye, apply a thin line of lash glue along the band, wait 30–40 seconds until tacky, place the centre first, secure the outer corner, then secure the inner corner.

Press the lash band close to your natural lash line so the strip looks cleaner, feels more comfortable and stays on better.

What this page covers

How to Apply Strip Lashes

The best strip lash application is usually simple rather than complicated. Most people get better results when they focus on fit, glue and placement instead of trying to rush the whole strip onto the eye in one movement.

For clean eyelash strip application, focus on these five things:

Fit the lash first The lash should not extend too far past your natural lash line.
Use thin glue A thin, even line is easier to control than thick glue.
Wait for tackiness Wet glue makes the lash slide instead of grip.
Place centre first This gives you better control over both corners.
Secure corners last Inner and outer corners need the most precision.
Press close to lash line This makes strip lashes look more natural.

If one of those goes wrong, the lash usually lifts, slides or looks less natural.

How to Apply Strip Lashes Step by Step

This is the easiest step-by-step method if you are learning how to apply strip eyelashes, how to apply eyelash strips or how to apply lash strips.

  1. Measure the lash against your eye. Hold the strip lash over your lash line before adding glue.
  2. Trim the outer end only. If the lash is too long, cut from the outer edge so the shorter inner corner stays intact.
  3. Apply a thin layer of glue. Run a fine line along the band and add a touch more to the inner and outer corners.
  4. Wait 30–40 seconds. The glue should feel tacky, not wet.
  5. Place the centre first. Start in the middle so the strip is easier to control.
  6. Secure the outer corner. Place the outer edge close to your natural lash line.
  7. Secure the inner corner. Press gently and avoid placing the lash too far into the inner eye.
  8. Press along the band. Make sure the strip is sitting close to the natural lash line all the way across.
  9. Blend if needed. A gentle squeeze with your fingers, tweezers or a lash applicator can help merge your natural lashes with the strip lash.

Best placement rule: centre first, outer corner second, inner corner last.

How to Put On Strip Lashes

If you are searching for how to put on strip lashes, how to put strip lashes on, how to put on lash strips or how to put lash strips on, the main mistake to avoid is trying to place the whole strip at once.

The easiest way to put on strip lashes is to look slightly downward into a mirror, place the centre of the lash first, then use tweezers or a lash applicator to secure each corner.

Mirror position Look slightly down into a mirror so you can see your lash line clearly.
Hand position Hold the lash from the centre, not one end.
Band position Place the strip on the skin just above your natural lashes, not on the waterline.

How to Apply Strip Lashes for Beginners

If you are learning how to apply strip lashes for beginners or how to put on strip lashes for beginners, start with lashes that are easier to control rather than the fullest lash style you can find.

The best strip lashes for beginners usually have:

  • a flexible band
  • a lightweight feel
  • a style that is easy to trim
  • a shape that suits your eye
  • enough structure to place cleanly without feeling stiff

Beginners usually get better results with a lash applicator, tweezers, a small mirror and enough patience to let the glue turn tacky before applying.

Beginner tip: if the lash feels stiff, too long or too heavy before glue, it will usually be harder to apply cleanly.

How to Apply Strip Lash Glue Properly

Glue technique matters just as much as lash style. If the glue is too wet, the lash slides. If there is too much glue, the band can look messy. If there is not enough glue on the ends, the corners lift.

How to apply strip lash glue properly:

  • use a thin, even layer across the band
  • add a tiny bit of extra glue to the inner and outer corners
  • wait 30–40 seconds for the glue to become tacky
  • avoid thick blobs of glue
  • do not apply the lash while the glue still looks very wet

Best rule: if the glue still looks very wet and shiny, wait a little longer before placing the lash.

Best Way to Apply Strip Lash Adhesive for a Natural Look

If you are asking what’s the best way to apply strip lash adhesive for a natural look?, the answer is: use less glue than you think, wait until it is tacky, and press the band as close to the natural lash line as possible.

For a natural-looking strip lash finish:

  • trim the lash to fit your eye width
  • use a thin line of adhesive
  • let the glue become tacky before placement
  • avoid placing the inner corner too far in
  • press the band close to your natural lash line
  • apply eyeliner if you want to disguise the band further

A natural strip lash look is usually less about choosing the shortest lash and more about making the band fit properly.

How to Trim Strip Lashes for a Better Fit

Trimming is one of the easiest ways to improve comfort and stop strip lash corners from lifting. A lash band that is too long will pull at the corners and feel uncomfortable.

  1. Measure the strip lash against your eye before adding glue.
  2. If it extends past your lash line, trim from the outer edge.
  3. Keep the shorter inner corner intact so the lash still looks natural.
  4. Trim a small amount at a time rather than cutting too much at once.
  5. Leave the lash slightly shorter than your full lash line if needed for better comfort.

Do not trim from the inner corner unless the lash style is specifically designed for it. Trimming the inner corner can make the lash look blunt and less natural.

How to Stop Strip Lash Corners Lifting

Strip lash corners lifting is one of the most common lash application problems. Usually, it happens because the lash is too long, the glue is too wet, not enough glue was added to the ends, or the band is too stiff for the eye shape.

To stop strip lash corners lifting:

  • trim the band properly before application
  • add a touch more glue to the inner and outer corners
  • wait until the glue is tacky before placement
  • choose a softer, more flexible lash band
  • press the corners down last and hold briefly
  • avoid placing the inner corner too close to the tear duct
If the outer corner lifts The lash may be too long or the outer edge may need more glue.
If the inner corner lifts The lash may be too close to the inner eye or the glue may not be tacky enough.
If the whole lash lifts The band may be too stiff, too wet or not pressed close enough to the lash line.

Common Strip Lash Mistakes

Using too much glue Too much glue makes the strip harder to control and more likely to slide.
Not waiting for tackiness Wet glue is one of the biggest reasons strip lashes refuse to stick properly.
Not trimming the band A band that is too long often feels uncomfortable and lifts at the edges.
Placing the lash too high This leaves a visible gap between your natural lashes and the strip lash.
Trimming the inner corner This can make the lash look blunt and less natural.
Using a stiff band Stiff bands can fight against your eye shape and lift faster.

Essential Tools for Better Strip Lash Application

Tool Why it helps
Strip lashes Choose a style that suits your eye shape, makeup style and comfort level.
Lash glue Secures the lash band and helps prevent lifting when used correctly.
Tweezers or lash applicator Gives more control when placing the centre and corners.
Small scissors Helps you trim the outer edge for a custom fit.
Mirror Looking slightly down into a mirror makes placement easier.

How Long Do Strip Lashes Last?

If you are asking how long do strip lashes last, there are two parts to the answer.

  • On the eye: strip lashes can last all day when applied properly with suitable glue.
  • As reusable lashes: they can last for multiple wears if cleaned, handled gently and stored properly.

Longevity depends on the lash quality, glue, fit, removal method and whether you keep the lash band clean after each wear.

Beauty Explained strip lashes for beginners and everyday glam
Shop the lash edit

Want Easier Strip Lash Application?

The right strip lash makes application easier. Flexible bands, flattering shapes and reusable styles are much more beginner-friendly than stiff, heavy lashes that fight against your eye shape.

Beginner friendly
Choose softer, easier-to-place bands.
Reusable value
Wear again with proper care.
Eye-shape friendly
Pick styles for almond, round or hooded eyes.
Better finish
Soft glam, natural or full glam options.

Current lash offer: selected lashes include free delivery and 3 for 2 at checkout where eligible.

Shop all lashes

Quick Tips for Better Results

Fit + tackiness + placement = better strip lash hold.

  1. Wait for the glue to become tacky.
  2. Trim from the outer corner only.
  3. Place the centre first.
  4. Do not push the inner corner too far in.
  5. Add extra glue to the edges if needed.
  6. Choose flexible bands if you struggle with lifting corners.
Shop lashes

Frequently Asked Questions

How do you apply strip lashes?

Measure and trim the lash, apply a thin layer of glue, wait until tacky, place the centre first, secure the outer and inner corners, then press the band close to the lash line.

How do you put on strip lashes for beginners?

Beginners usually do best with lighter lashes, a flexible band, proper trimming and a centre-first placement method.

How long should I wait after applying lash glue?

Usually 30–40 seconds, or until the glue feels tacky rather than wet.

Why do strip lash corners lift?

Corners usually lift because the lash is too long, the glue was too wet, there was not enough glue on the ends, or the band is too stiff.

Where should I trim strip lashes?

Trim from the outer corner only so the shorter inner edge stays more natural-looking.

How do you apply strip lash glue properly?

Apply a thin, even line of glue across the band, add a little extra to the corners, and wait until the glue becomes tacky before placing the lash.

How long do strip lashes last?

A properly applied pair should usually last the day, and reusable strip lashes can last for multiple wears if cleaned and stored carefully.

What is the best way to apply strip lash adhesive for a natural look?

Use a thin layer of adhesive, wait until it is tacky, place the band close to the lash line and avoid placing the inner corner too far into the eye.

Continue Reading

→ Shop all lashes → The Lash Mastery Guide → Find the best lash style for your eye shape

 

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.